Forums

/ / /

Prev Go to previous topic

Go to next topic

Last Post 09/20/2012 6:05 PM by heythisisaj

Creating a sketch report

0 Replies

Sort:


You are not authorized to post a reply.

Author

Messages

heythisisaj
Guest

Guest
Posts:1

09/20/2012 6:05 PM
Hey ya'll, I'm a newbie to this website, but not a newbie to Xactimate. However, I am trying to increase efficiency with the reports I do on a day to day basis, and I've never figured out how to get a document of just my sketch, with all of the measurements showing (sometimes, if its over 20-25 squares, the measurements get lost) and the 3-d images showing? Is there an easy way to do this? Currently, I just use snagit and snag every aspect of the sketch that I need and throw it into an excel sheet to save to a PDF later. Thanks in advance for any advice you have.

You are not authorized to post a reply.

These Forums are dedicated to discussion of Claims Adjusting.

For the benefit of the community and to protect the integrity of the ecosystem, please observe the following posting guidelines:

No Advertising.
No vendor trolling / poaching. If someone posts about a vendor issue, allow the vendor or others to respond. Any post that looks like trolling / poaching will be removed.
No Flaming or Trolling.
No Profanity, Racism, or Prejudice.
Terms of Use Apply

Site Moderators have the final word on approving / removing a thread or post or comment.